*EndFLD()Specifies the end of the FLD block. |
|
|
|
|
|
*EndFLD()Specifies the end of the FLD block. |
|
|
|
|
Specifies the end of the FLD block.
*EndFLD()Specifies the end of the FLD block. |
|
|
|
|
|
*EndFLD()Specifies the end of the FLD block. |
|
|
|
|
Syntax |
*EndFLD() |
Example |
*BeginFLD() *BeginStudy("Study 1", "On") *BeginFLC() *Engineering("On") *CurveSource("Math", "0.20 1.00") *EndFLC() *BeginSelection(Part, SelectVisible) *Add("all") *EndSelection() *ResultType("Strain") *Layer("Lower") *LegendType("Zone") *Compression("UseAngle", 45, "On") *Margin(10, "On") *LooseMetal(2, "On") *FitCurve("On") *EndStudy() *EndFLD() |
Application |
HyperView. |
Comments |
This marks the end of the FLD block. |
See also |
|