HyperMesh and BatchMesher

Stop Angle Implementation

Stop Angle Implementation

Previous topic Next topic No expanding text in this topic  

Stop Angle Implementation

Previous topic Next topic JavaScript is required for expanding text JavaScript is required for the print function  

Normally, the stop angles are given by load curves.  The second and last curve points are used to determine the stop angle.  If a load curve has less than four entries, the first and the last entries are used.  You can find the implementation of the stop angle in the HM_JOINT_INFO function in the function template of the PAM-CRASH 2G Interface.  If load curves are not defined for a joint, default values for stop angles ( -270°C to +270°C ) will be displayed in the Dummy Positioning panel.

 

 

See Also:

Dummy PositioningTool Start Macro

PAM-CRASH 2G Materials Supported for Dummy Positioning

Update Initial Rotation Angle in the JOINT Card