Command Sets Panel - Properties Tab

command_sets_panel

Command Sets panel - Properties tab

Command set types include:

Write

Causes the Templex template to be written at that location in the solver command file.

command_set_write

Forces

The *SetForce() command set statement writes a force statement to the solver command file. This statement sets the value of the force to the specified value when the solver acts on that line in the command file.

Simulate

Exports the simulation commands to the solver command file.

Motion

The *SetMotion() command set statement writes a motion statement to the solver command file. This statement sets the value of the motion to the specified value when the solver acts on that line in the command file.

SetState

One command set can be active in any one analysis task. MDL saves the state of each command set in the *SetState() statement.