HyperMesh and BatchMesher

3D Shell - Edge Based

3D Shell - Edge Based

Previous topic Next topic No expanding text in this topic  

3D Shell - Edge Based

Previous topic Next topic JavaScript is required for expanding text JavaScript is required for the print function  

Use the 3D shell – edge based option to define the *SURFACE card by specifying edge identifiers for 3D shell elements. The edges are displayed by special contactsurface elements.  Face identifiers for solids with shell coating are defined by picking nodes on a specific edge and sweeping through a break angle. Therefore, the Nodes on edge option is always selected.

contact_mgr_surface_tab_define_5

3D shell – edge based enables the following:

Button

Action

Elements

Opens the Element Selector panel, from which you can select underlying 3D shell elements from the graphic area. The selected elements are highlighted. The corresponding Reset button resets the selected elements.

Nodes

Opens the Node Selector panel, from which you can select nodes from the graphic area. Two nodes from the same solid element must be picked to define a edge of that shell. The selected nodes are highlighted. The corresponding Reset button resets the selected nodes.

Note:Several two-node sets can be selected at the same time to define edges in different elements.

Add

Finds all edges from the selected 3D shells that fall within a specified break angle of the edge(s) defined by nodes.  These edges are then added to the current surface and special contactsurface elements are created for display.

Note:You cannot add duplicate contactsurfaces for the same element in HyperMesh. Therefore, the Add button does not check for duplicates and there is no Reject button.

 

 

See Also:

3D Solid or Gasket

3D Shell, Membrane, or Rigid Elements

3D Solid Coated with Shell

2D Solid, Axisymmetric, or Gasket Elements

Beam, Pipe, or Truss Elements

Element Set

Element Based Surface: Define Tab