On the Undo-Redo toolbar, you can access undo and redo functionality.

Turn the toolbar on and off by clicking View > Toolbar > HyperMesh > Undo-Redo from the menu bar.

Not all the actions performed in HyperMesh can be undone or redone. If an operation does not support undo/redo, the undo/redo functionality will be disabled once the action is completed and any previous undo/redo history recorded will be reset. The undo/redo history will also be reset every time a macro or other tcl application is invoked.

 

Undo/Redo Settings

---

By default, the number of undo actions is set to 100 and the maximum undo memory (MB) is set to 2500. Both of these settings can be modified in the Undo/Redo Settings dialog. To access this dialog, click Preferences > Undo/Redo Settings from the menu bar.

Undo/redo history may use a large amount of memory. By default, a threshold of 80% of the total memory limit will not be exceeded. Once the memory threshold is exceeded, all older actions will be automatically purged.

 

Undo

---

Undo an action by clicking , or pressing CTRL+Z.

Simultaneous actions can be undone by selecting them from the Undo drop-down menu.

Redo

---

Redo an action by clicking , or pressing CTRL+Y.

Simultaneous actions can be redone by selecting them from the Redo drop-down menu.

 

 

*The undo/redo functionality is supported by most HyperMesh panels, tools, and user interface functionalities. Support will be complete in future releases.