|
»Click here to display Table of Contents«
|
HyperForm 14.0.130 Release Notes |
|
|
|
|
|
HyperForm 14.0.130 Release Notes |
|
|
|
|
| • | Support for addendum in Blank fit |
| • | Support for nesting of fitted blanks along with blank boundary. |
| • | Support for Chevron and Sweep fit in blank fit and batch nesting |
| • | Support for normal force in simplified draw bead model setup. |
| • | Nesting of more than 2 parts is very slow. |
| • | Failure to define edge blank holder force in one step process |
| • | Holes in the blank shape not transferred from Blank fit manager to blank nesting |
| • | Interference of tube with tools during tool reversal motion after each bend. |
| • | Solver error in gravity setup for multilayered blanks |
| • | Multistage run not working in batch mode if constraints are defined on the blank |
| • | Hydro bending model setup stops with error when center of tool rotation is not at origin. |
| • | Runs to infinite loop if any one part fails during the batch process |
| • | Slow performance in reading input files |
| • | Conflict of Part-part margin with part – carrier gap in progressive die nesting |
| • | Pitch definition not as per industry standards |
