Linux/Mac Entity Selection: When a body is selected in a browser on Linux, all the mesh lines of the graphics of that body were highlighted. This is now resolved

Pick center choice with Ctrl+Middle mouse button was not being honored correctly. The graphics used to rotate about a different center than selected. This issue is fixed.

ADM files with expressions having large blank spaces from the beginning of the line leads to expressions being truncated. This issue is fixed in this release.

Import of ADM that did not contain MATRIX information for flexible body resulted in crash of application. This issue has been fixed.

Issues related to incorrect modes and interface nodes while converting .h3d files to .mnf files and .mnf to .h3d files are resolved within this release.

Erroneous GENSTIFF and SELNOD matrix was being written out while converting .h3d to .mtx when using kgf as the solver unit. This issue is fixed within this release.

An application error while using Create RBE2 spiders option in flex prep is fixed. The error appeared while closing HyperMesh button with the Close (x) button.

A custom ID specified for a graphic entity was lost on Check Model. This issue is fixed.

MotionView would not report error when components specified in *Graphic statement of File type were missing. This issue has been fixed.

An application error while changing the mesh scheme for File Graphics under a Graphic system is fixed.

An issue with false referencing of entity due to use of same variable names in a system as well as at Model level is now fixed. When an entity (e.g. p_0) that existed at Model level was referenced in a system that contained entity of same type and same variable name (p_0) was being saved with a local address (p_0 instead of MODEL.p_0).

White spaces in the USER expression in Sensor entity evaluate subroutine resulted in the expression being truncated. This issue is resolved.

Setting of MAF export option was lost on model save. This issue has been resolved.

Statics simulation settings - Maximum # of iterations is now defaulted to 75 

Write results data per time option is now set to LAST by default instead of ALL. This resolves issues in post-processing due to multiple results at certain time steps in a sequential simulation.

Outputs of type Entity sets on bodies used to result in many outputs with the same label. This issue has been resolved.

An application error in Curve panel while changing type from File to Values is fixed. The error was encountered when a file path was unresolved.

An application error encountered while using the Back/Forward button in any panel is resolved. The error used to occur while using the button after deleting an entity that was in the selection history.