HyperMesh and BatchMesher

Element Based Surface: Delete Face Tab

Element Based Surface: Delete Face Tab

Previous topic Next topic No expanding text in this topic  

Element Based Surface: Delete Face Tab

Previous topic Next topic JavaScript is required for expanding text JavaScript is required for the print function  

Surfaces can be displayed in two ways: by special face elements or by contactsurfaces. The surfaces defined on 3D solid, gasket, shell, membrane, rigid elements are displayed by face elements while surfaces on 2D solid, axisymmetric, gasket and all beam, pipe, truss elements are displayed by contactsurfaces.  In the Delete Face tab, delete faces or contactsurface from all elements types.  It contains tools to find and delete duplicate faces for 3D solid, gasket, shell, membrane, or rigid elements.

There are three options for deletion: (a) All, or (b) By element, and (c) Duplicate faces.

contact_mgr_delete_face

(a) All enables the following:

Button

Action

Delete

Deletes all the faces or contactsurfaces in the current surface.

(b) By element enables the following:

Button

Action

Element Faces

Opens the Element Selector panel.  For 3D solid, gasket, shell, membrane, and rigid elements, pick the faces (not the underlying elements).  However, for 2D solid, axisymmetric, gasket or all beam, pipe, truss elements, pick the elements themselves as the contactsurfaces can not be picked from the graphic area. The corresponding Reset button resets the selected elements.

Delete

Deletes the selected faces or contactsurfaces from the selected 2D solid, axisymmetric, gasket, beam, pipe, truss elements.

(c) Duplicate faces enables the following:

Button

Action

Find Duplicate Faces

Finds duplicate faces, if any exists, for the current surface and highlights them in the graphic area. The status bar shows the number of duplicates found. The corresponding Reset button resets the selected elements.

Delete

Deletes the highlighted duplicate faces found.

Note:Duplicate contactsurfaces cannot be added to the same surface in HyperMesh.  Therefore, Duplicate Faces is only valid for 3D solid, gasket, shell, membrane, and rigid elements.

 

 

See Also:

Element Based Surface: Define Tab

Element Based Surface: Adjust Normal Tab

Element Based Surface: Optional Parameters Tab