HyperMesh and BatchMesher

Load Step: CLOAD

Load Step: CLOAD

Previous topic Next topic No expanding text in this topic  

Load Step: CLOAD

Previous topic Next topic JavaScript is required for expanding text JavaScript is required for the print function  

In Abaqus, *CLOAD can have degrees of freedom (dof) 1 through 6.  In HyperMesh, concentrated loads with dofs 1 through 3 are called force and those with dofs 4 through 6 are called moments.  The force and moments are two separate entities that are defined from separate panels.  Their graphical displays are also different.  As a result, Step Manager has two distinct tree options for *CLOAD: CLOAD-Force and CLOAD-Moment.

In the CLOAD-Force dialog, define the *CLOAD card for dofs 1 through 3 and the CLOAD-Moment for dofs 4 through 6.  Open Concentrated loads in the tree, select CLOAD-Force or CLOAD-Moment, and a load collector from the Load collector table to open the corresponding dialog in the right-most section of the Load Step window.

It is recommended that you do not use both CLOAD–Force and CLOAD-Moment in the same load collector in HyperMesh.  If you need to use both types of *CLOAD in the same STEP, define each type in a separate load collector and add them to the same load step.

Each dialog contains three tabs:

Define

Delete

Parameter

step_mgr_cload_define_tab

 

 

See Also:

Load Collector

Abaqus Step Manager: Load Step Dialog

Abaqus Step Manager Overview