Load Step: Temperature: Define Tab
|
»Click here to display Table of Contents«
|
|
Load Step: Temperature: Define Tab |
|
|
|
|
|
|
Load Step: Temperature: Define Tab |
|
|
|
|
In the Define tab, define *TEMPERATURE cards on individual nodes or geometry (surfaces, points, lines). You can also define the temperature on node sets
It is recommended that you do not use *TEMPERATURE and *BOUNDARY with dof 11 together in a load collector in HyperMesh. If you need to use multiple types of temperature in the same STEP, define each type in a separate load collector and add them to the same load step.
You can define *TEMPERATURE on nodes, geometry, or node sets. For Define Temperature on:, the following options are available:
The layout of the Define tab changes, based on your selection.
See Also:
