*sethvlaunchflag

The following command will allow you to set the default state of the Launch HyperView after H3D creation switch located in the HyperMesh Options panel.

Syntax

*sethvlaunchflag mode

Type

HyperMesh Tcl Modify

Description

The following command will allow you to set the default state of the Launch HyperView after H3D creation switch located in the HyperMesh Options panel.

Inputs

mode
Enable/disable the launch flag:
0 - Disable HyperView launch.
1 - Enable HyperView launch.

Example

This command is used in the command file.

Errors

None.