CTRIAX6

Bulk Data Entry

CTRIAX6 – Axisymmetric Triangular Element Connection

Description

Defines an axisymmetric triangular cross-section ring element for use in linear analysis.

Format

(1)	(2)	(3)	(4)	(5)	(6)	(7)	(8)	(9)	(10)
CTRIAX6	EID	MID	G1	G2	G3	G4	G5	G6
	Theta

(1)	(2)	(3)	(4)	(5)	(6)	(7)	(8)	(9)	(10)
CTRIAX6	111	203	31	74	75	32	51	52
	15.0

Field	Contents
EID	Unique element identification number. No default (Integer > 0)
MID	Identification number of a MAT1 or MAT3 entry. No default (Integer > 0)
G1,G3,G5	Identification numbers of connected corner grid points. Cannot be omitted. No default (Integers > 0, all unique)
G2,G4,G6	Identification numbers of connected edge grid points. Cannot be omitted. No default (Integers > 0, all unique)
Theta	Material orientation angle in degrees. Default = 0.0 (Real or blank)

Comments

1.	All the grid points must be located in the x-z plane of the basic coordinate system with x = r > 0, and ordered consecutively starting at a corner grid point and proceeding around the perimeter in either direction.

Corner grid points G1, G3 and G5 must be present. The edge points G2, G4 and G6 are optional. If any of the edge points are present, they all must be used.

ctriax6

CTRIAX6 definition

2.	The continuation is optional.

3.	If MID is defined on a MAT3 entry, material properties and stresses are always given in the (xm, zm) coordinate system shown in the figure above.

A concentrated load (for example, the load specified on a FORCE entry) at a grid Gi of this element denotes that applied onto the circumference with radius of Gi. For example, in order to apply a load of 200N/m on the circumference at Gi which is located at a radius of 0.4m, the magnitude of the load specified on the static load entry must be:

(200 N/m) * 2 * (0.4m) = 502.655N

5.	CTRIAX6 and CTAXI elements cannot be used simultaneously in an input model.

6.	This card is represented as an element in HyperMesh.