/FAIL/USER1, FAIL/USER2 OR /FAIL/USER3 /HEAT/MAT /INITHICK/V5 /RADIATION /RUN/Run Name/Run Number/Restart Letter /TABLE |
CHEXA (8-noded) CHEXA (20-noded) CPENTA (6-noded) CPENTA (15-noded) CPYRA (5-noded) CPYRA (13-noded) CTETRA (4-noded) CTETRA (10-noded) NLOAD (Constraint Load) NLOAD (Case Control) NSM (Global Case Control Card) PEAKOUT (Control Card) PEAKOUT (Load Collector) RSPEC (Case Control) RWALL (Group) RWALL (Case Control) XHIST (Output Block) XHIST (Case Control) XSTEP (Load Collector) |
To create Abaqus cards, load the Abaqus user profile and select the appropriate template (Standard.2d, Standard.3d, or Explicit). The supported Abaqus cards: *CONNECTOR CONSTITUTIVE REFERENCE *CONTACT DAMPING (Explicit template) *CONTACT DAMPING (Standard templates) *CONTACT PROPERTY ASSIGNMENT, PROPERTY=OFFSET FRACTION *CONTACT PROPERTY ASSIGNMENT, PROPERTY=THICKNESS *FRICTION (Standard templates) *INITIAL CONDITION (TYPE=STRESS) *INITIAL CONDITION (TYPE=PRESSURE) *INITIAL CONDITION (TYPE=TEMPERATURE) *INITIAL CONDITION (TYPE=VELOCITY) *SURFACE BEHAVIOR (Explicit template) *SURFACE BEHAVIOR (Standard templates) *SURFACE INTERACTION (Explicit template) *SURFACE INTERACTION (Standard templates) |
The following Actran blocks are supported:
BOUNDARY_CONDITION MESH |
The input translator recognizes the ANSYS cards listed below. If an unsupported field is found in a card, a message is displayed on the status bar. The messages are also printed to the file ansys.msg. General slash commands, SOLUTION commands, POST1 commands, and POST26 commands are referred to as control cards. Unrecognized cards are written to a *.hmx file.
|
|
The following cards are supported in MADYMO:
|
DIST LOADS (CONTROL CARD) |
The following cards are supported in Nastran:
CHEXA (20-noded) CHEXA (8-noded) CPENTA (6-noded) CPENTA (15-noded) CTETRA (4-noded) CTETRA (10-noded) MARCOUT RSPEC TSTEPNL (Load Collector) TSTEPNL (Control Card) |
The following cards are supported in PAM-CRASH: |
The following cards are supported in PAM-CRASH 2G:
|
The following cards are supported in PERMAS: $CONDUCTIVITY - materials $CONDUCTIVITY - loads
|
.FRA
|