*CE_ConnectorAreaTrim

Syntax

*CE_ConnectorAreaTrim mark_id node_mark_id tolerance snap mode

HyperMesh Tcl Modify

Trim/split area connectors using nodes.

mark_id: The ID of the mark containing the area connectors to trim. Valid values are 1 and 2..
node_mark_id: The ID of the mark containing the trim/split nodes. Valid values are 1 and 2..
tolerance: The tolerance value used to snap the nodes to the points of area connectors when snap is 1.
snap: 0 - Do not snap nodes to area connectors.; 1 - Snap nodes to area connectors.
mode: 0 - Split area connectors.; 1 - Trim area connectors.

To split area connector 101 using node 1001:

*createmark connectors 1 101
*createmark nodes 1 1001
*CE_ConnectorAreaTrim 1 1 0.5 1 0

Incorrect usage results in a Tcl error. To detect errors, you can use the catch command:

if { [ catch {command_name...} ] } {
   # Handle error
}

13.0.110