*nodecreateatlineparams

Syntax

*nodecreateatlineparams line_id double_array number_of_doubles insert_count mode point_flag

HyperMesh Tcl Modify

This command creates nodes or points at points on given line for given parametric values.

line_id: Input line ID.
double_array: The ID of the double array that contains the parametric location values in the range 0 to 1. The double array is created using the *createdoublearray command. This should always be set to 1.
number_of_doubles: Integer indicating the size (number of doubles) in the double array created using *createdoublearray.
insert_count: Number of additional parametric values inserted between the values specified by the array in double_array.
mode: Specifies how parameters specified in double_array are used. Valid values are:; 0 – Line arc length parameterization is used.; 1 – Internal line parameterization is used.
point_flag: Parameter specifying whether nodes or points are created. Valid values are:; 0 – Create nodes (default); 1 – Create points

To create nodes on line 12 at arc length parametric values 0.2, 0.8 and 0.85:

*createdoublearray 3 0.2 0.8 0.85
*nodecreateatlineparams 12 1 3

To create 10 points on line 12 using the line’s internal parameterization with parameters equally distributed between 0 and 1:

*createdoublearray 2 0 1
*nodecreateatlineparams 12 1 2 8 1 1

Incorrect usage results in a Tcl error. To detect errors, you can use the catch command:

if { [ catch {command_name...} ] } {
   # Handle error
}

10.0