*CE_ConnectorSeamTrim

Syntax

*CE_ConnectorSeamTrim mark_id node_mark_id tolerance snap mode

HyperMesh Tcl Modify

Trim/split seam connectors using nodes.

mark_id: The ID of the mark containing the seam connectors to trim. Valid values are 1 and 2.
node_mark_id: The ID of the mark containing the trim/split nodes. Valid values are 1 and 2.
tolerance: The tolerance value used to snap the nodes to the point of seam connectors when snap is 1.
snap: 0 - Do not snap nodes to seam connectors.; 1 - Snap nodes to seam connectors.
mode: 0 - Split seam connectors.; 1 - Trim seam connectors.

To split seam connector 101 using node 1001:

*createmark connectors 1 101
*createmark nodes 1 1001
*CE_ConnectorSeamTrim 1 1 0.5 1 0

Incorrect usage results in a Tcl error. To detect errors, you can use the catch command:

if { [ catch {command_name...} ] } {
   # Handle error
}

13.0.110