*morphaltercurvectr

Syntax

*morphaltercurvectr domtype dommark nodetype holdnode type curve sym con hold mode node plane line project force add

Type

HyperMesh Tcl Modify

Description

Alter the radius, curvature, or arc angle of edge or 2D domains on mark.

Inputs

domtype: DOMAINS
dommark: Domain mark number
nodetype: NODES
holdnode: Node mark number
type: The type of alteration to be made:; 0 - Alter radius; 1 - Alter curvature; 2 - Alter arc angle
curve: Numerical value by which to alter the curve; actual effect depends on the type previously specified and the value of the add flag listed at the end of the command:; If type = 0 - New radius; type = 1 - Curvature multiplier; type = 2 - New arc angle; add =1 and type = 0 - Number added to radii; add =1 and type = 2 - Number added to arc angle
sym: 0 - Do not use symmetry (only option)
con: Flag to use/not use constraints:; 0 - Do not use constraints; 1 - Use constraints
hold: Specifies which part of the curve to anchor:; 0 - Hold angle; 1 - Hold ends; 2 - Hold center
mode: Method of determining center or edges of curve:; 0 - Edge approximation, use symmetry; 1 - Use axis for center; 2 - Use line for center; 3 - Infer center using normals; 4 - Use node for center; 5 - Edge approximation, do not use symmetry
node: ID of node
plane: Mark number of plane
line: ID of line
project: Flag to project curve edges to a plane:; 0 - Do not project edges to plane; 1 - Project edges to plane
force: Flag to force circular edges when using edge approximation (mode option 5):; 0 - Do not force edges to be circular (edge approximation only); 1 - Force edges to be circular (edge approximation only)
add: Determines whether the value specified for curve is added to the existing curve’s value, or replaces it:; 0 - Use 'curve' as target value; 1 - Add 'curve' to current value(s)

Example

*morphaltercurvectr (DOMAINS,1,NODES,1,1,5.0,0,1,0,0,32,1,43,0,0,0)

The domains on the marks will have either their radius, curvature, or arc angle altered depending on 'type'. If add is set to 1, 'curve; will be added to the current radii or arc angle of the selected domains, otherwise the radii or arc angle will be set to 'curve'.

This command allows you to choose the mode used to determine the center for the selected domains. Only one of 'node', 'plane', or 'line' needs to be filled in depending on mode (or none if 0, 3, or 5 is selected).

Setting project to 1 will force the nodes for an edge to lie in a plane as part of the altered curve. Setting force to 1 will force the calculated center for each node of an edge to be the same point, thus forcing the edge to be circular after the curve is altered.

If constraints are used they will be applied to the perturbations. Symmetry is not supported for *morphaltercurvectr().

Errors

None.